ICS Cutting Tools
WOOD DRILLS

wood drill - side and front view

Wood (Brad Point) Drills are made of chrome vanadium steel and will stay sharp much longer than high carbon tool steels. Center spur point holds drill on target and prevents walking. Two cutting edges drill a perfectly round clean hole. Will not tear wood grain or splinter.
 
    WOOD DRILLS - BRAD POINT
spacer
Wood Drills - Precision Ground
Brad Point Drills are designed to drill smooth, accurate holes in wood with minimum tear-out. Center spur point holds drill on target and prevents walking when two cutting spurs make contact with surface so even overlapping holes can be drilled. Drills are made of chrome vanadium steel and will stay sharp much longer than high carbon tool steels.
Wood Drills - 12" Long
Extra Length Brad Point Drills are used to eliminate then need for extensions when drilling deep holes or where longer reach is needed.
Wood Drill Sets
7 Piece Drill Set.
spacer
    WOOD DRILLS - PERFECT POINT®
spacer

Wood Drills - Precision Ground
Perfect Point® Drills are designed to drill perfectly round, clean, flat bottom holes or through holes without splintering or tearing wood grain surface. They are unique in that they do not tear wood grain when breaking through exit side of hole. They outperform and last three to five times longer than Brad Point Drills, Dowel Drills, and Forstner Bits.
Wood Drill Sets
7 Piece Drill Set.
Wood Drills - Precision Ground- 1/2" Shank
Perfect Point® Drills are designed to drill perfectly round, clean, flat bottom holes or through holes without splintering or tearing wood grain surface. They are unique in that they do not tear wood grain when breaking through exit side of hole. They outperform and last three to five times longer than Brad Point Drills, Dowel Drills, and Forstner Bits.
Wood Drill Sets - 1/2" Shank
8 Piece Drill Set.

Find out more about ICS Cutting Tools Perfect Point ®
spacer
    TAPER POINT DRILLS
spacer

Taper Point Drills for Wood Screws
Taper Point Drills are designed to drill tapered holes in wood and plastic to match a wood screw’s thread and shank in one operation. They fit most counterbores and countersinks. Shank diameter is the same as the drill size.

Taper Point Drill and Countersink Combination
Taper Point Drill and Countersink Combination tools allow you to drill and countersink wood screw holes in one operation. A stop collar is included to control depth of hole.
spacer
 

Copyright © 1994-2012 by ICS Cutting Tools, Inc. All rights reserved. No part of this page may be reproduced by any mechanical, photographic, or electronic process, or in the form of a phonographic or digital recording, nor may it be stored in a retrieval system, transmitted, or otherwise copied for public or private use without written permission of the publisher.